Adjust your function generator to output 100 Hz, 2v pp sine wave signal Depending on the frequency of the input waveform, enter an appropriate sampling frequency number. There are some additional optional components and the wiring you see in the diagram: After connecting all the wires as shown in Fig.18, proceed to the front panel and fill in the appropriate information on the front panel as described below: Testing Low & High Channel as 0 for Channel control. If the terminals are not connected appropriately, the tool bar will display the status as shown in Fig 17.įinal Step On completion and if the wiring is correct, the diagram should look like the one shown in Fig. As said before if a connection is bad or is not appropriate, it will show on the diagram with a broken line. When your implementation is complete, the tool bar will show the status of the VI. Connect the graphing indicator on towards the end of your construction. Using the wire tool, connect the appropriate controls to the sub-VI as shown in Fig 18. Check the connections again with the "Help" screen or by looking at Fig 18. an array to a number or a cluster to an array). ![]() This means that the wire connection is carrying incompatible data (e.g. If the connections between two functions/sub-VIs are incompatible, then a dotted (-) line will appear between the connections rather then a solid line. This makes it easy to connect the wire to appropriate terminals. When the wire tool is placed over a function or a sub-VI, the terminals on the functions light up with the connections highlighted. With Help turned on, as you move your editing tool on a function/sub-VI the help screen will pop up. To look at all the connections, go to the Help menu and choose "Show Help". While designing a diagram remember the following rules: For any Function or sub-VI the inputs to it are always to the left and the outputs are always to the right. The tool bar is used for choosing different tools. Final Step - Connecting the boxes At this point it is important to understand the tool bar.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |